Tech Tip: How to Use Variables in Patterns to Vary Features

Tech Tip: How to Use Variables in Patterns to Vary Features

In today’s Tech Tip, we will discuss how to use variables in conjunction with sketches and patterns to vary geometry.

Variables in Onshape can be used in patterns and their values can be incremented through instances of the pattern. In this example, we’ll use a 8×8 fan cover that has slots varying not only in width, but also in count and spacing as they get further from the center.

To create the fan cover, you need to start with the variables. Each variable should be defined twice. The first is the initial value.

The second variable defines how it varies with the pattern.

All the variables you need for the grate are below:

Name: Slot_Width

Type: Length

Initial Value: .3in

Equation: #Slot_Width+.05in

Name: Slot_Spacing

Type: Length

Initial Value: .4in

Equation: #Slot_Spacing +.08in

Name: Slot_Count

Type: Number

Initial Value: 8

Equation: #Slot_Count-1

Next, draw a slot in the center of the plate and extrude cut it.

cut slot

TIP: Constraints in sketches to outside geometry are ignored when patterning. Sometimes it is necessary to make sure that outside references are deleted and replaced with a fixed constraint to ensure the sketch will adjust appropriately in the pattern.

The full grate is created using two linear patterns and a mirror. The first pattern includes the sketch of the slot and the extrude cut centered about the seed. Distance is set to #Slot_Spacing, while Instance count is set to #Slot_Count. Use a horizontal edge to define the direction.

The second pattern must include #Sloth_Width, #Slot_Count, #Slot_Spacing, slot sketch, extrude, and the original linear pattern. This is where all the variation occurs. Distance and instance count are not linked to any variables. Make sure “Apply per instance” is checked to recalculate the features for each instance. Otherwise, it will just pattern the existing geometry.

Note: Be careful not to select the initial variables because they do not vary.

Finally, mirror the faces of the resulting holes to finish the grate.

TIP: Box select from left to right to only capture the faces of the holes that are fully encompassed by the box.

This is a simple example, but it shows the many ways a variable can change geometry in a pattern. Check out the Advanced Part Design class in the Onshape Learning Center for more advanced tips.

Interested in learning more Onshape Tech Tips? You can review the most recent technical blogs here.

Lindsay Early

Lindsay Early is a Senior Technical Services Engineer for Onshape at PTC. Previously, she was an Elite Application Engineer and PDM Expert in the SOLIDWORKS Reseller channel. Lindsay holds a Bachelor’s degree in Biomedical Engineering from Rensselaer Polytechnic Institute. She enjoys spending time with her four rambunctious boys, swimming, biking, tabletop games, and movies.

Onshape’s Greatest Tech Tips (Volume 1)

This free guide provides step-by-step instructions on how to use some of Onshape’s most powerful and unique features.


Read the eBook

Be the first to comment

Leave a Reply

Your email address will not be published.


*